Kenwood VR-5900 - Manual (Page 113)

105
T
roubleshooting
Receiver/Tuner
3. Touch . Every time you select the button the volume will cycle
between 0dB, -3dB, -6dB and back up to 0dB.
4. While the source component is playing, reduce the Input Level to -
3dB. If the CLIP indicator still flashes frequently or remains lit for 1
second or longer, reduce the Input Level again to -6dB.
5. Touch to return to the Setup menu.
I can’t access any RDS (Radio Data System) functions (for U.K. only)
•
Confirm that the radio station is broadcasting RDS.
• Make sure you use the Auto Memory function to store RDS stations in
memory. See “Storing RDS Stations Automatically” on page 41 of the
Connections and Setup Guide.
I can’t receive a radio station
Check that:
• The appropriate antenna is connected. See Chapter One of the Con-
nections and Setup Guide.
• The broadcast band is correct. See “Tuner” on page 57 of this manual.
• The tuner is set to the correct frequency. See “Tuner” on page 57 of
this manual.
I’m getting a lot of static/interference
•
Check whether the receiver or antenna is too close to a TV or other
electrical appliance.
• Adjust the antenna for best reception.
• If you live in an area with weak FM signals, consider a rooftop or an
amplified FM antenna (available at any home electronics store).
When I press a button to tune to a preset station, the receiver does
not respond
Check whether:
• The receiver has been unplugged for more than three days. If it has,
your settings were cleared from the receiver’s memory. See “My re-
ceiver won’t turn on and the STANDBY indicator is flashing” on
page 103 of this manual.
• The Tuner input is selected. See “Tuner” on page 57 of this manual.