Kenwood KDC-MP635 - Manual (Page 49)

English | 49
Hold Error: The protective circuit in the unit activates
when the temperature inside the automatic
disc changer exceeds 60°C (140°F), stopping
all operation.
➪ Cool down the unit by opening the
windows or turning on the air conditioner.
As the temperature falls below 60°C
(140°F), the disc will start playing again.
No Name: Attempted to display DNPS during the CD
play having no disc names preset.
Waiting: Text for the Satellite Radio tuner source is
being received.
Load: Discs are being exchanged in the Disc
changer.
Reading: The unit is reading the data on the disc.
IN (Blink): The CD player section is not operating
properly.
➪ Reinsert the CD. If the CD cannot be
ejected or the display continues to flash
even when the CD has been properly
reinserted, please switch off the power
and consult your nearest service center.
Protect (Blink): The speaker wire has a short-circuit or
touches the chassis of the vehicle, and then
the protection function is activated.
➪ Wire or insulate the speaker cable properly
and press the reset button. If the "Protect"
code does not disappear, consult your
nearest service center.
Unsupported File:
An Audio file is played with a format that this
unit can’t support.
➪ ----
Copy Protection:
A copy-protected file is played.
➪ ----
DEMO MODE (Blink):
The Demonstration mode has been selected.
➪ The (page
40) is ON. Turn it OFF.
No Device: The USB device is selected as a source
although no USB device is connected.
➪ Change the source to any source other
than USB. Connect an USB device, and
change the source to USB again.
N/A Device: An unsupported USB device is connected.
➪ For the supported USB devices, refer to
.
No Music Data/ Error 15:
• The connected USB device contains no
playable audio file.
• Media was played that doesn’t have data
recorded that the unit can play.
USB Error: The connected USB device is rated a current
capacity higher than the allowable limit.
➪ Check the USB device with reference to
.
Some trouble may have occurred to the
connected USB device.
➪ Change the source to any source other
than USB. Remove the USB device.
iPod Error: Connection to the iPod has failed.
➪ Remove the USB device and then
reconnect it.
➪ Confirm that the software for the iPod is
the latest version.
USB REMOVE: The Remove mode has been selected for the
USB device. You can remove the USB device
safely.