Kenwood KDC-MP635 User Manual
Page 15
English
|
15
Display Type F
G-Analyzer display Selection
Changing the G-Analyzer display.
⁄
• Before alternating G-Analyzer display, you are required to
setup
(page 18).
1
Enter G-Analyzer display selection mode
Using the Control knob, select "DISP" >
"GMENU".
For the operation method, refer to
2
Select the G-Analyzer display
Turn the Control knob.
Select from the following displays.
G-Force Sensor display
G- Graphic display
1 – 2
G-Meter display
(Graphic)
G-Meter display
(Text)
G-Counter display
⁄
• G-Graphic display
Displays the condition of G in horizontal direction
(e.g; when turning the curve) by the graphic.
• G-Meter display (Graphic)
Displays the maximum value of acceleration G, right
direction G, and left direction G by the numerical value.
• G-Meter display (Text)
The maximum value of acceleration G, right direction G,
and left direction G is displayed by the numerical value.
The value of G is only the reference, so is different from
the actual value.
• G-Counter display
Adds the point of the acceleration level. The point is
determined after a lapse of 1 hr drive or at power off
(ACC Off ), and then it will be displayed by the graph.
Furthermore, the G-Counter displays the average of the
past data by the line. (The scale of graph is determined
along with the largest point among the past 10 data.)
• The value of G-Meter display and G-Counter display can
be reset by
3
Exit G-Analyzer display selection mode
Press the Control knob.