Kenwood KDC-MP635 - Manual (Page 47)

English | 47
Some functions of this unit may be disabled by
some settings made on this unit.
! Cannot switch to Aux source.
▲ • AUX is not turned on. ☞
Setting> (page 38)
• AUX cannot be used when the KCA-iP200 is
connected.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
▲ • (page 10) is not set to On.
• The Dual zone function is enabled. ☞
Setup> (page 9)
!
• Cannot set up the high pass filter.
• Cannot set up the Fader.
▲ The Dual zone function is enabled. ☞
Setup> (page 9)
!
Cannot set up the subwoofer phase.
▲ Low pass filter is set to Through. ☞
(page 9)
! • Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear speakers.
▲ The Dual zone function is disabled. ☞
Setup> (page 9)
! No Audio control effect on AUX.
▲ The Dual zone function is enabled. ☞
Setup> (page 9)
!
• Cannot register a security code.
• Cannot set up Display Illumination Control.
▲ (page 40) is not
turned off.
! Cannot play audio files.
▲ (page 38) is set to "2".
!
• Cannot File select.
• Cannot direct music serch.
▲ The Random play function is enabled.
Troubleshooting Guide
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
? The Touch Sensor Tone doesn’t sound.
✔ The preout jack is being used.
☞ The Touch Sensor Tone can’t be output from the
preout jack.
Tuner source
? Radio reception is poor.
✔ The car antenna is not extended.
☞ Pull the antenna out all the way.
✔ The antenna control wire is not connected.
☞ Connect the wire correctly, referring to the
section on
(page 44).
Disc source
? The specified disc does not play, but another one
plays instead.
✔ The specified CD is quite dirty.
☞ Clean the CD.
✔ The disc is loaded in a different slot from that
specified.
☞ Eject the disc magazine and check the number
for the specified disc.
✔ The disc is severely scratched.
☞ Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔ The media is scratched or dirty.
☞ Clean the media, referring to the CD cleaning of
the section on (page 6).
✔ The audio file is broken or not supported.
☞ Damaged and unsupported files are skipped.
✔ The recording condition is bad.
☞ Record the media again or use another media.