Kenwood KDC-MP635 - Manual (Page 35)

English | 35
In Standby mode
Date Mode
Setting the date format.
1 Select Date Mode
Turn the Control knob.
Select the "Date Mode" display.
2 Enter Date mode
Press the Control knob for at least 1 second.
3 Select the date format
Turn the Control knob or push it towards up or
down.
4 Exit Date mode
Press the [FNC] button.
In Standby mode
DSI (Disabled System Indicator)
A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
Display Setting
"DSI : ON" LED flashes.
"DSI : OFF" LED OFF.
Display Illumination Control
This function turns off the display when you
perform no operation for 5 seconds. This function is
effective when you are driving at night.
Display Setting
"Display : ON" Keeps the display on.
"Display : OFF" Turns off the display when you perform no
operation for 5 seconds.
⁄
• Set the Display Illumination Control when the
(page 40) is set to OFF.
• When the display is off, pressing any key will turn on the
display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Turning off the power
• During function control, such as the Menu System, the
display stays on.
In Standby mode
Dimmer
Dimming this unit’s display automatically when the
vehicle light switch is turned ON.
Display Setting
"Dimmer : ON" The display dims.
"Dimmer : OFF" The display doesn’t dim.
In Standby mode
Built-in Amp Setting
Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP : ON" The built-in amplifier activates.
"AMP : OFF" The built-in amplifier deactivates.