Mounting to hummer rack – KVH Industries KVH TracVision User Manual
Page 6
Installation
54-0239
TracVision A5 Shop Manual
© 2004 KVH Industries, Inc., All rights reserved.
• KVH’s Hummer kit is designed only for standard 2"-thick Hummer
roof rack crossbars.
• Position the roof rack crossbars 39
1
/
2
" apart, measured center-to-
center.
• Cut each crossbar’s rubber strip into three pieces as shown
above. These measurements are critical to position the T-nuts
properly.
• Always use the tamper-resistant TORX and pin-in-hex hardware
supplied in the kitpack. Do not use any substitutes.
Mounting to Hummer Rack
Effective April 2004
Subject to change without notice
Flat Washer
Pin-in-hex Screw
Crossbar
T-nut
(in center channel)
Button-head
TORX Screws
T-nuts
19" Rubber Strips
26.25" Rubber Strip
Crossbar