KVH Industries KVH TracVision - Manual (Page 18)

54-0239 TracVision A5 Shop Manual © 2004 KVH Industries, Inc., All rights reserved.
DO...
• DO terminate the antenna cable with the supplied Snap-N-Seal
F-connector.
• DO use an Augat tool to install F-connectors.
• DO check the integrity of the F-connectors. Resistance measured
between center conductor and shield should indicate an open
circuit.
• DO maintain a bend radius of at least 3" when routing the antenna
cable.
• DO use high-quality video cables between receiver and
monitor(s).
• DO tighten all connections adequately.
• DO use the rubber boot to protect the antenna connector.
DO NOT...
• DO NOT use a screw-on, push-on, twist-on, or any other over-the-
counter connector to terminate the antenna cable. Low-quality
connectors will degrade system performance and may damage
the TracVision equipment.
• DO NOT kink or stress the antenna cable.
Do’s and Don’ts - Wiring
Effective April 2004
Subject to change without notice
Do’
s & Don’ts