KVH Industries KVH TracVision - Manual (Page 5)

Installation
54-0239 TracVision A5 Shop Manual © 2004 KVH Industries, Inc., All rights reserved.
• KVH’s roof-mount kit is designed only for flat metal roofs up to
3 /
16
" thick.
• Install a jack nut in all eight
7
/
16
" mounting holes. Ensure the jack
nuts are securely attached to the roof.
• At least 1" clearance is required between the underside of the
antenna and the roof. To raise the antenna higher, use the
spacers supplied in the kitpack (see page 3 of the roof-mount
instructions for details).
• Always use the tamper-resistant TORX hardware supplied in the
kitpack. Do not use any substitutes.
Mounting to the Roof
Effective April 2004
Subject to change without notice
Cover
Flat-head
TORX Screws
Mounting Block
Jack Nuts
Button-head
TORX Screws
Mounting Bracket
Antenna