KORG TRITON Musical Instrument - Manual (Page 44)

TRITON Training Guide
42
A Word About Output Bussing
The ability to send oscillators, timbres and tracks to individual outputs has never been easier! As an
example, in Combination mode, just select the bus for each timbre - in the P8: Edit - Insert Effects Routing
page (as viewed in the previous section) to outputs L/R, 1-4, 1/2 or 3/4, patch from the selected output to
your mixer or amplifier, and you're all set! You can even send a timbre through Insert effects before going to
an Individual output - we'll look at that later in this guide.
Working with the Audio Inputs and Effects
On the TRITON's back panel, you'll find two audio inputs, with a LINE / MIC impedance switch and a gain
level control. These inputs can be used to process external signals through the TRITON's internal effects,
and as the source inputs for using the TRITON in Sampling mode.
For the following exercise, you'll need a microphone, cable and a line -matching transformer (lo-hi
impedance transformer) if your microphone is lo-impedance.
Connect the microphone and set the input level:
1. Connect a microphone to the rear panel Input 1 connector and set the MIC / LINE switch to MIC.
2. Press the COMBI key to enter Combination mode, then select Combination A000 Romance Layers.
3. Press the GLOBAL key to enter Global mode, press the MENU key, then press P0: Basic Setup.
4. Press the Audio Input tab.
5. In the Input 1 field, press Pan: L000 and type 64 + ENTER on the numeric keypad to set the pan value
to C064 (center).
6. In Input 1's BUS Select field, press the popup button, and set the BUS to L / R. Then, just below
BUS Select, press the 000 value, and use the DIAL to set the Send 1 (MFX1) level to 100, and the Send
2 (MFX1) level to 040. Now speak into the microphone to hear the signal being processed with the
Master effects (MFX1 and 2). (Master effects from Combination A000). Note that even when the BUS
Select is set to OFF, if the send levels are above 000, the input signal will go direct to the Master effects.
If the send levels are at 000 and the BUS Select is set to L / R, signal will be sent dry - to the L / R
outputs.
7. Press the popup button and select IFX1 from the popup menu. Speak into the mic to hear the signal
being processed by Insert effect 1. Continue to select and try the other IFX busses. To view and edit the
Insert effects, set the audio input BUS Select, press the COMBI key, then press the MENU key. Press
P8: Edit - Insert Effects, then press the Insert Effect tab to view IFX1-5, and depending on which BUS
Select you've chosen for the audio input signal, press the corresponding IFX tab - to edit the Insert effect
while speaking into the microphone. If you want to edit a Master effect that's processing the audio input