KORG TouchView Trinity ProX - Manual (Page 54)

03: Multiband Limiter
50
03: Multiband Limiter
This effect applies the Limiter to the low range, mid range, and high range of the input signal. You can
control dynamics for each range to adjust the sound pressure of the low range, mid range, and high range
in a different way from the EQ.
a Ratio 1.0:1…50.0:1, Inf:1 Sets the signal compression ratio. ☞ P.15
b Threshold [dB] –40…0dB
Sets the level above which the compression is applied.
☞ P.15
c Attack 1…100 Sets the attack time. ☞ P.16
d Release 1…100 Sets the release time. ☞ P.16
e Low Offset [dB] –40…0dB Gain of the low-range trigger signal
☞
P.50
f Mid Offset [dB] –40…0dB Gain of the mid-range trigger signal ☞ P.50
g High Offset [dB] –40…0dB Gain of the high-range trigger signal ☞ P.50
h Gain Adjust [dB] –16…+24dB Sets the output gain.
☞
P.15
i
Wet/Dry Dry, 1:99…99:1, Wet Sets the balance between the effect and dry sounds.
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
e: Low Offset [dB]
f: Mid Offset [dB]
g: High Offset [dB] These parameters set the input gain of the trigger signal.
For example, if you do not want to apply compression to the high range, reduce
the High Offset value down below the Threshold level. In this way, the high
range limiter will not respond, and compression will not be applied.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Gain Adjust
Mid Offset
Low Offset
High Offset
Limiter
Envelope - Control
Envelope - Control
Envelope - Control
Limiter
Limiter
Low
Mid
High
Band-Pass Filters
+