KORG TouchView Trinity ProX - Manual (Page 144)

18: Hold Delay
140
18: Hold Delay
This effect records the input signal and plays it back repeatedly. You can control the start of recording and
reset via a modulation source. Easy to use for real-time performances.
a Loop Time [msec] Auto, 1…2700msec
Sets Automatic loop time setup mode or specifies loop
time.
☞ P.140
b REC Control Src None…Tempo Selects control source for recording. ☞ P.140
c RST Control Src None…Tempo Selects control source for reset. ☞ P.141
d Manual REC Control REC Off, REC On Recording switch ☞ P.140
e Manual RST Control Off, RESET Reset switch
☞
P.141
f
Pan L100…L1, C, R1…R100 Sets the stereo image of the effect.
Src None…Tempo Modulation source of stereo image of the effect
Amt –100…+100 Modulation amount of stereo image of the effect
g
Wet/Dry Dry, 1:99…99:1, Wet Sets the balance between the effect and dry sounds.
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
a: Loop Time [msec] With Auto, the loop time is automatically set. Otherwise, you can specify the
loop time.
When Auto is selected, the Loop Time is automatically set to the time it takes for
a performance recorded while the Modulation Source or Manual Rec Control is
on. However, if the time length exceeds 2,700msec, the loop time will be auto-
matically set to 2,700msec.
b: REC Control Src
d: Manual REC Control REC Control Src selects the modulation source that controls recording. If this
modulation is on, or if Manual REC Control is set to REC On, you can record the
input signal. If a recording has already been carried out, additional signals will
be overdubbed.
The effect is off when a value for the modulation source specified for the
REC Control Src parameter is 63 or smaller, and the effect is on when the
value is 64 or higher.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Pan
Delay
D -mod
D -mod
Loop Time: Auto/ ...2700ms
+
REC Control
RST Control