KTI Networks KS-2262 User Manual

Page 27

2-1-4-2. Configuring the Management Agent through the Ethernet Port

There are three ways to configure and monitor the switch through the switch’s
Ethernet port. They are CLI, Web browser and SNMP manager. The user interface
for the last one is NMS dependent and does not cover here. We just introduce the
first two types of management interface.

͒͒͒͒CCCCManaging L2 MANAGED SWITCH through Ethernet Port

Before you communicate with the switch, you have to finish first the
configuration of the IP address or to know the IP address of the switch. Then, follow
the procedures listed below.

1. Set up a physical path between the configured the switch and a PC by a

qualified UTP Cat. 5 cable with RJ-45 connector.

Note: If PC directly connects to the switch, you have to setup the same
subnet mask between them. But, subnet mask may be different for the PC
in the remote site. Please refer to Fig. 2-9 about the switch’s default IP
address information.

2. Run CLI or web browser and follow the menu. Please refer to Chapter 3

and Chapter 4.

Default IP Setting:
IP = 192.168.1.1
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254

Assign a reasonable IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254

Fig. 2-9

Ethernet LAN