KORG D1600 - Manual (Page 32)

KORG D1600 Guided Tour
32
16. Press the METER / TRACK VIEW key, then press the PLAY key to playback and view the post fader
levels for Tracks 13 and 14.
17. When you're finished playing back the mixdown, press the STOP key, then press the IN / LOC1 key to
locate to the song beginning.
Work with the Clipboard, Fade, and Undo functions:
The following exercises use the current song…
Set an OUT point for the bounced audio tracks:
1. Press the SONG key, then press the “Counter” and use the DIAL to set it to read: “001:12.000”.
2. Press the STORE key, then press the OUT/LOC2 key, to set an OUT point (the IN point is already set to
the beginning of the song).
Copy the selected audio region to the “Clipboard”:
The “Clipboard” allows you to copy selected data from one song to another. The IN and OUT points set in
the previous steps indicate a selected audio range. The TO point needs to be set in the destination song
only if you want the audio data in the Clipboard to be copied to a location other than the beginning of the
song.
3. Press the TRACK key, then press the “EditTrk” tab.
4. Press the “>” popup button and press to select the “Copy” radio button, followed by pressing the “OK”
button.
5. Press to highlight the “edit cell” “1” in the left area of the display, then rotate the DIAL to read “13-14”.
6. Press to highlight the “edit cell” “1” above the “EditTrk” tab, then rotate the DIAL to read “Clip2”. Note:
The edit cell reads “Clip2” when two or more tracks have been copied, and reads “Clip1” when a single
track is copied.
7. Press the “Exec.” button, then press the “Yes” button. Press the “OK” button to copy tracks 13b and
14b to the Clipboard.
Copy the Clipboard contents to a new song:
This is an efficient way to “import” your two track mixdown to a new song, where no effect or EQ processing
is assigned to tracks 1 and 2.
8. Press the SONG key, then press the “New” button in the display, followed by pressing the “OK” button.
9. Press the TRACK key, and press to highlight the “edit cell” “1” in the left area of the display, then rotate
the DIAL to read “Clip2”.
10. Press to highlight the “edit cell” “1” above the “EditTrk” tab, then rotate the DIAL to read “1-2”.
11. Press the “Exec.” button, then press the “Yes” button. Press the “OK” button to complete the copy
procedure.
12. Press the METER/TRACK VIEW key, then press the PLAY key, and raise the Channel 1 and 2 faders
and MASTER fader for playback, avoiding clipping.