Work with the lead vocal track in “sister dance, Set a new locate point in the song, Work with the lead vocal (track 1) insert effect – KORG D1600 User Manual

Page 18

KORG D1600 Guided Tour

Work with the lead vocal track in “SISTER DANCE”:

1. Press

the

Channel 1 TRACK STATUS key so that it lights green (un-muted). Tracks 4, 7, 8, 9 and 10

should also be un-muted (TRACK STATUS keys lit green).

Set a new Locate Point in the song:

2. Press

the

IN/LOC1 key to reset the song to the beginning.

The display should still be on the INSERT

EFFECT page.

3. Press to highlight the “Counter”, and use the DIAL to set it to “000:30.000”.

4. Press

the

PLAY key to resume playback from this point.

5. As the song plays, listen to the lead vocal track. Just after the first verse ends, press the STORE key and

then press the OUT/LOC2 key. This sets an “on-the-fly” locate point for you to use as you go through the
following steps and audition new insert effects for the lead vocal track. Let the song continue for now…

Note:

The default setting for all four locate keys is at the beginning of each new song.

Also Note: Waveform viewed Locate points can be stored by using the SCRUB function, for setting even

more precise locations. More on this in the following exercises:

Work with the lead vocal (Track 1) Insert effect:

6. As the song continues, press the OUT/LOC2 key, and then press the “InsEff1” tab at the bottom of the

display.

As you audition effects while the song plays, press the OUT/LOC2 key whenever you like, to

reset to the stored locate point and continue playback

7. Press to highlight the effect number “I105”, to the left of the effect name button. This is a microphone

modeling/limiter chain, assigned to the lead vocal track.

8. Slowly rotate the DIAL left or right, to select and listen to new insert effects.

Note that you’ll find

additional mic modeling effects in locations “I101-108”.

9. Rotate

the

DIAL until you recall effect “I105”, then press the “MM33:MicSM57/414” button, followed by

pressing the “MicSim” and “Limiter” effect “icons” to view, select and adjust a few parameters for
these effects.

Tip:

Once you’ve edited an effect, the display will indicate “EDIT” to the left of the effect name. You can
then press the “Store” button in the display, and save the new effect to one of 128 user effect
locations. Note that the factory user effects are identical to the preset effects. For more information,
see the D1600 Owner’s Manual, page 46.