Kurzweil KSP8 TM - Manual (Page 73)

MIDI Mode
The RECEIVE Page
Preliminary - Subject to Change 10-3
Keep in mind that the setting of the Veltouch parameter in Master mode also has an effect on the
transmit velocity map.
Pressure Map—Transmit (PressMap)
This is like the VelocMap, but it controls the aftertouch values sent by the PC3 to its MIDI Out
port. Use this exclusively to adjust the response of MIDI devices connected to the PC3’s MIDI
Out port. Changing the pressure map on this page does not affect the response of the PC3’s
sound engine to its own keyboard, or to an external MIDI controller. That’s done on the
RECEIVE page. See Chapter 18 of the Musician’s Guide for information about editing pressure
maps.
Program Change (PChng)
When On, the PC3 sends program change commands to its MIDI Out port when you select
programs or setups from the front panel or from your MIDI controller. Select a value of Off
when you want to change programs on the PC3 but don’t want to send program change
commands to the MIDI Out port. This parameter doesn’t affect the type of program change
command that’s sent; it just determines whether any command is sent at all. (The type of
program change command is determined by the settings for three parameters on the CH/PRG
page in the Setup Editor.)
Change Setups (ChgSetups)
This parameter determines the exact timing of setup changes when you select a different
setup—either by a normal data entry method or via MIDI program change commands. Choose
KeyUp
to indicate that you want setup changes to take place only when you’ve released all
currently held notes. Choose Immed to indicate that you want such changes to happen
immediately when you select the setup.
The RECEIVE Page
Press RECV to select the RECEIVE page, where you define the PC3’s response to incoming
MIDI signals (with one exception pertaining to Quick Access mode, which we’ll explain later).
Parameter Range of Values Default
Basic Channel 1 to 16 1
MIDI Mode Omni, Poly, Multi Multi
All Notes Off Normal, Ignore Normal
Program Change Mode Program Change Type List Extended
Velocity Map Velocity Map list 1 Linear