Kodak A-61555 - Manual (Page 64)

4-4 A-61555 May 2010
3. The printer carrier slides easily along the rail. There is a small arrow
on the green printer carrier. Slide the printer carrier to the desired
position aligning the arrow with the detent position on the rail.
4. Close the printer access cover.
5. Reinstall the output tray.
NOTE: Printing automatically stops approximately ½-inch (1.27 cm)
from the trailing edge of the document, even if the information
has not been completely printed.
Changing the rear
horizontal print position There are 8 horizontal print positions. These positions are visible by a
small detent on the printer rail.
1. Lift the top access cover.
2. The printer carrier slides easily along the rail. There is a small arrow
on the green printer carrier. Slide the printer carrier to the desired
position aligning the arrow with the detent position on the rail.
3. Close the top access cover.