Kodak A-61555 - Manual (Page 33)

A-61555 May 2010 3-15
Feeding documents
using multi-feed
detection The scanner has three multi-feed detection sensors that can be
independently enabled or disabled. When multi-feed detection is
enabled, adjust the side guides so the documents fully cover at least
one sensor. If the document partially covers a sensor, false multi-feeds
may occur.
Automatic feeding To scan a stack of documents follow the guidelines for size, type,
quantity, etc., outlined in the “Document preparation” section.
For faster throughput, place documents into the input elevator in
landscape orientation (longer side as the leading edge).
IMPORTANT: Staples and paper clips on documents may damage the
scanner. Remove all staples and paper clips before
scanning.
1. Align the leading edges of the stacked documents.
2. Position the stack of the documents, face up in the input elevator so
the stack covers the paper present sensor.
NOTE: For Kodak i1800 Series Scanners, Firmware Version 2.1.X
(or higher): When the i1800 Series Scanner is powered-on
and paper is added to the elevator tray, the elevator will rise
to the “ready to feed” position. If you need to lower the
elevator tray after it has risen, you can either press the
Lower Elevator button (lowers to the 500-sheet position) or
move the stack of documents slightly away from the paper
present sensor and the elevator tray will return to the
original Paper Source position (e.g., 250 Sheet, 500 Sheet,
etc.).
Depending on how your capture application software is configured,
your documents will automatically start feeding, or you may need to
touch the Scan button on the touchscreen to begin feeding
documents.