Kodak A-61555 - Manual (Page 54)

3-36 A-61555 May 2010
2. Select Print Offset. The following screen will be displayed.
3. Use the up and down arrows to increment or decrement the print
offset value (in inches or mm). The printing will be incremented/
decremented from the value that is set up in the capture application
software. For example, if you have printing set up to start 1 inch/25
mm from the lead edge of the document, and you increment the
print offset position by 1 inch / 25 mm, printing will start at 2 inches/
50 mm from the lead edge.
NOTE: The top- and outer-most arrows will increment/decrement
the value in larger increments (values of 1 inch/25 mm).
The inner most arrows, closest to the center, will increment/
decrement the value in 1/8-inch / 3 mm increments.
4. When finished, click OK.
Disabling the Printer The Disable Print function allows you to temporarily disable printing on
all documents in a batch. This may be useful if rescanning a stack of
documents that have already been printed.
The Disable Print function is only available after the scanner is enabled
(scanning started from the host PC). If you want to disable printing for
the first document in the batch, then your host software should be set
up to NOT automatically start scanning.
The Disable Print button is only available if printing has been enabled
by the scanning application. Once Disable Print is turned on, no
documents will be printed on until one of the following occurs:
• Disable Print is turned off, or
• the scanner is disabled because there are no more documents to
scan (End Job) or a multifeed occurs and the scanner is set up via
the Stop Scanning option on jam.
increments in 1-inch/
25 mm segments
increments in 1/8-inch/
3 mm segments
decrements in 1 inch/
25 mm segments
decrements in 1/8-inch/
3 mm segments