Kodak A-61555 - Manual (Page 15)

2-2 A-61555 May 2010
8 Service K-Number — the number on this sticker is the number
you will be asked to provide when placing a call Kodak Service.
9 POD release latch — push up the POD release latch when you
need to access the inside of the scanner.
10 Output tray and end stop — collects the scanned documents.
The output tray width and end stop length can be adjusted.
11 Exit deflector — aids in document stacking.
12 Printer access cover — lift this cover to access the front printer
for changing printer positions and maintenance.
13 Top access cover — lift this cover to access the rear printer for
changing printer positions and maintenance.
14 Touchscreen — a variety of functions can be performed using the
touchscreen. See Chapter 3, Using the Scanner for procedures on
using these functions. If you need to move the scanner, the
touchscreen can be rotated so it will easily fit through doorways or
tight spaces.
15 LED — flashes green when the scanner is in Power Saver/Energy
Star mode; LED is steady green when the scanner is idle and
ready to scan.
16 Workspace table height adjustment switch — used to raise and
lower the workspace table on the scanner. The workspace table
can be raised or lowered approximately 10 inches up or down.
17 Height Adjustment Wire — located underneath the output tray
(not shown in photo), this wire can be pulled out to raise the front of
the output tray.
8
9
10
11
12
13
14
15
16
18