Kawasaki STX-15F - Manual (Page 283)

PUMP AND IMPELLER 11-13
Pump and Impeller
JT1500-A2 ∼ ;
•
Replace the grease seals with new ones, if necessary,
and install them.
Special Tool - Bearing Driver Set: 57001-1129
○
Press each seal [A] into the pump case [B] so that the side
with the spring faces outward.
○
Fill the gap between the grease seals [C] with high grade
water resistance grease and apply it each greace seal lip
[D].
•
Install the circlip [E].
•
Install the bushing [F] into the pump case.
○
Fill with high grade water resistance grease [G].
•
Install a new bearing into the pump case [A] as far as it
will go.
Special Tool - Bearing Driver Set: 57001-1129 [B]
•
Visually inspect the pump shaft O-rings [A], and replace
if necessary.
•
Install the O-ring over the pump shaft [B].
○
Grease the O-ring with high grade water resistance
greace.
•
Apply molybdenum disulfide greace [A] to the thread of
the pump shaft
•
Push the pump shaft [B] into the pump case.