Konica Minolta Q-M100 - Manual (Page 101)

Error message
● When the remaining exposure counter reads “Err” and all indicators
appearing on the indicator panel are blinking, there is an error in camera
control.
If the camera falls into such the status:
1) close the lens barrier, if it is open, and
2) press the MONITOR POWER switch to turn off the LCD monitor.
If the camera does not recover from the error status in spite of the
above-mentioned operation:
1) disconnect the AC adapter from the camera if it is connected, and
2) remove all batteries from the camera.
Leave the camera as it is in the above-mentioned status for 1 hour or so,
and then set new batteries in the camera.
If the same error occurs after replacement of batteries, consult with the
store that you got the camera at about the matter.
When the cause of the error is removed by the above-mentioned proce-
dure, the calendar and clock are initialized. Therefore, reset them refer-
ring to Setting calendar and clock.