Kenwood HM-332 - Manual (Page 38)

Application section
38
1
3
2
down
volume/
multi control
up
TIME ADJUST
12:00 m a
TIME ADJUST
8:00 m a
TIME ADJUST
8:07 m a
menu
down
volume/
multi control
up
set/demo
set/demo
Clock adjustment
Activate the clock adjustment mode.
Press and hold for more than 2
sec. when the power is ON.
1 Enter the figure of hour.
Enter the figure of hour.
÷ The time display starts to blink.
2 Set it.
Example: Adjustment to 8:07
To decrease
hour To increase
hour
÷ The time of the day is represented in 12-hour am/pm
method.
÷ Press the set/demo key. The hour is entered and the
minute display starts to blink.
1 Enter the figure of minute.
Enter the figure of minute.
2 Set it.
To decrease
minute To increase
minute
Example: Adjustment to 8:07
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the set/
demo key, the display shows “COMPLETE”.
÷ After a power failure or the power cord has been un-
plugged then plugged in again, it is required to set the
time again.
÷ When the 7STOP key is pressed while the power is in
the standby mode, the time of the day will be displayed
for 5 seconds.
As the clock is not used to show the time of the
day but is also used in timer operations, be sure
to set the clock in advance.