Kodak A-61003 - Manual (Page 47)

A-61003 September 1993 FB-7
IMPORTANT: Do not unload a partially exposed roll of film
when using duo mode. Images will be lost if
a partial roll is unloaded.
It is assumed that all documents have been deposited in the
exit hopper and the Stop key has been pressed.
1. Enter function code F28 Film Leader. This will result in six
(6) feet of film being advanced onto the take-up spool,
protecting the filmed images.
2. Open the cassette access door.
3. Swing the drive release lever (green handle) out.
4. Remove film cassette(s).
5. Place the cassette on a flat surface, with the top cover
side up.
6. Press down on the cover latch and turn counterclockwise
to unlock the cover.
7. Remove the top cover and set it aside.
8. Slide the release lever toward the battery compartment
and hold it in this position.
9. Place a finger over the take-up spool flange to prevent
the film from unwinding.
10. Cut the film with a pair of scissors; cut where indicated
in the illustration (between the idler roller and the
take-up spool).
UNLOADING A
PARTIALLY EXPOSED
ROLL OF FILM