Kodak A-61003 - Manual (Page 34)

A-61003 September 1993 OM-7
Code Operator Message Displayed Description/Action Required
E231 Press JOG, and try again Press the Jog key. Press the Run key.
Try again.
E232 Close all access doors and RUN Close all access doors.
Press the Run key to continue.
E233 Close cassette access door Close the cassette access door.
Press the Run key to continue.
E234 Press JOG, and try again Press the Jog key. Press the Run key.
Try again.
E235 Turn main power OFF and ON Turn the side panel switch off.
E236 Turn the main power switch off.
Wait five (5) to ten (10) seconds.
Turn the main power switch on.
Turn the side panel switch on.
If the error repeats, call service.
E237 Open and close cass access door Open and close the cassette access door.
Press the Run key to continue.
E238 User function string invalid The P-Key, End-of-Batch, etc. definition
made during installation is invalid.
Correct the definition using the Mode
Setup Software.
E240 Enter correct level of IA - refeed Set or change the document image level
E241 or use the Next key to enter a new Image
E242 Address.
E243 Press the Run key to continue.
E244
E245
E246 Conflicting input - what level? Set or change the document image level
to confirm the proper document image
level.
Press the Run key to continue.
E249 Select duo or change cassettes Complete the proper setup for duo mode
or change cassette(s).
E250 Use other side of upper cassette Rotate the film cassette to film on the
proper side.
Reload the film cassette into the machine.