Kodak A-61003 - Manual (Page 32)

A-61003 September 1993 OM-5
Code Operator Message Displayed Description/Action Required
E203 Cassette info does not match Use the NEXT key to enter the correct
Image Address, or
change cassette(s).
E204 Skewed document - refeed Press the Clear key.
Use the NEXT key to enter the correct
Image Address and refeed
document(s).
E205 Level overflow - press next level Press the Clear key.
Use the NEXT key to enter the correct
Image Address, or
press a level key for a higher level.
E206 Check print head Install the correct Document Printer
print head.
E207 Check printer installation Document Printer not correctly installed.
Properly install the Document Printer
print head.
E208 Change DSA lamp Replace the DSA lamp.
E209
E210 Approaching end of film Enter function code F30 to determine the
amount of film remaining.
Press RUN to continue filming, or
begin filming on a new roll.
E211 Enter correct Image Address Use the NEXT key to enter correct Image
Address.
E212 End of side 1, flip cassette Turn cassette over, and
reinsert in the proper orientation.
Press the Run key to continue.
E213 End of side 2, start trail code Enter function code F32 to generate
trail end code.
E214 Document length error - refeed Press the Clear key.
Use the NEXT key to enter the correct
Image Address and refeed document(s).
E215 No image mark - Refeed by hand Select a document image level.
Press the Run key and refeed
document(s).