Kodak A-61003 - Manual (Page 31)

A-61003 September 1993 OM-4
Code Operator Message Displayed Description/Action Required
E129 Dirty AEC sensor Perform maintenance/cleaning
procedures.
If the message repeats, call service.
E130 OCR not installed Requested action requires installation of
the OCR accessory.
E131 Device not enabled Requested action requires installation of
the Bar Code Reader.
E132 Enable barcode first Requested action requires that you
E133 enable the Bar Code Reader.
Enter function code F60 to enable
bar code reading.
E140 Document Printer not installed Requested action required installation of
E141 Patch Reader not installed the module/accessory indicated.
E142 Detection System not installed The required module/accessory is
E143 Barcode Reader not installed not installed.
E144 Image Marker not installed
E145 Endorser not installed
E146 Document Sorter not installed
E158 Check battery - upper cassette Replace battery in upper cassette.
E159 Check battery - lower cassette Replace battery in lower cassette.
E170 Film writer error Call service.
E190 Sorter in improper position The Sorter was not able to or did not
access the specified or proper bin.
Press the Jog key. Press the Run key.
Try again.
E200 Verify/enter Image Address An error has occurred in the system and
E201 the Image Address may no longer be
correct.
Use function code F08 to determine the
last Image Address.
Use the NEXT key to correct the Image
Address, if necessary.
E202 Change film mode or cassette(s) Replace the cassette(s) with one(s) that
match the film mode setup, or
change the film mode setup.