Kodak A-61003 - Manual (Page 16)

A-61003 September 1993 FC-4
Function Code Name/
Code Description Additional Input
F01 Select Mode • Enter the number of the application mode
Allows you select one of the you wish to select; one or two digits.
eighteen (18) application • Press the Enter key.
modes.
F02 Restore Mode none
Allows you to restore the
current application mode to
its default status (as it was
defined at installation),
provided that mode overrides
are not saved.
F03 Filming Only • Enter the number one (1) to turn
Allows you to film documents, Filming Only ON; or
with no level counting, enter the number zero (0) to turn
endorsing, patch reading, Filming Only OFF.
etc. • Press the Enter key.
F04 Counting Only • Enter the number one (1) to turn
Allows you to count Counting Only ON; or
documents only, with no enter the number zero (0) to turn
filming, scanning, etc. Counting Only OFF.
• Press the Enter key.
F05 Accessory Status • Press the down arrow key to view the status
Allows you to display the of the next accessory; or
current status of each press the up arrow key to view the status
accessory installed. of the previous accessory.
• Press the Clear key at any time to return to
a normal operating display.
F06 Terminate Batch • Press the Clear key to return to a normal
Allows you to prematurely operating display.
end a batch.
F07 Level 0 none
Allows you to assign Level 0
to the next document fed
into the transport.
FUNCTION CODE LISTING