KITCHENAID YKGRT507 User Manual
Page 19
19
5.
If the surface light still does not work,
you may need to replace the starter. The
starter is a knob-shaped part located on
the right side of the backguard, under the
light tube.
To remove and replace the starter, first
remove light tube. Push starter in and
turn approximately 90° counterclockwise.
Pull starter out of recessed area. You can
find replacement starters at stores that
sell fluorescent light tubes.
6.
Replace glass and close the top panel.
7.
Plug in range or reconnect power.
U
sing and
C
aring for
Y
our
C
ooktop
See also other documents in the category KITCHENAID Radio:
- KERS205TBT2 (7 pages)
- YKGRT607 (28 pages)
- KDRS807SSS01 (13 pages)
- ARCHITECT SERIES II KESS907 (32 pages)
- KGRS205TWH5 (10 pages)
- 9752043 (5 pages)
- KDRP767RSS00 (10 pages)
- KERA807 (32 pages)
- KDRU763VSS00 (11 pages)
- KDRP463LSS0 (12 pages)
- KESC308 (28 pages)
- KERS807 (32 pages)
- ARCHITECT YKESS907 (32 pages)
- KERA205PBL (2 pages)
- KERA205PSS2 (8 pages)
- KDRP407HSS12 (10 pages)
- ARCHITECT KERS206X (36 pages)
- KERA807 KESI901 (32 pages)
- KDRP463LSS04 (12 pages)
- KERI500 (44 pages)
- ARCHITECT KERS308X (36 pages)
- W10044930B (16 pages)
- KESC307 (67 pages)
- ARCHITECT KESK901 (32 pages)
- W10162196A (1 page)
- KERS205TBL3 (7 pages)
- KDRP462LSS07 (12 pages)
- KERH507 (54 pages)
- KDRP407HSS3 (10 pages)
- KDRP707RSS00 (10 pages)
- KDRP407HSS (10 pages)
- KDRP707 (36 pages)
- KDRP407HSS09 (10 pages)
- KDRP462LSS04 (12 pages)
- KDRP487MSS03 (10 pages)
- KERC506 EN (24 pages)