Kodak A-61602 - Manual (Page 82)

A-61602 January 2008 79
Replacement
procedures
Replacing the pre-
separation pad Degradation of feeder performance, multiple feeds, stoppages, etc.
indicate a need to change the pre-separation pad. Certain paper types
such as carbonless paper or newsprint, or failure to clean regularly,
and/or use of non-recommended cleaning solvents can shorten the pre-
separation pad life.
For additional pre-separation pads, see the section entitled, “Supplies
and Consumables” later in this chapter.
1. Open the scanner cover by pressing the release lever.
2. Squeeze the plastic clamps that hold the pre-separation pad in
place and lift the pre-separation pad out of position.
3. Insert the new pre-separation pad into position, aligning it into the
slots, and pushing it in until it snaps into place.
4. Close the scanner cover.