Siemens 1015N-2MFM-1A - Manual (Page 6)

2
1015N-2MFM-1A
3. TECHNICAL SPECIFICATIONS
Interface: RS-232
Supply Voltage: 5 volts DC
Supply Current: 48 mA
Modem Line Speeds: 2400, 1200 and 300 bps Asynchronous
DTE Rates: 2400, 1200, 300 bps
Modulation: V.22bis, V.22, Bell 212A, Bell 103
Phone Line: Dial Up or 2 Wire Leased Line
Extended Hayes Command Set Compatibility
Error Correction / Error Detection: None
Operating Environment:
-40 to 85 degrees C / 0 to 95% Humidity (non-condensing)
4. 1010N FLOWMETER SYSTEM REQUIREMENTS
The System 1010N Flowmeter operating system must be revision level 2.0 or later for the
1015N-2M Modem Card to function properly. In addition, the 1015N-2M Modem Card
requires 1010N system hardware of the following levels in order to work. Refer to the
appropriate 1010N user manual installation/outline drawings for circuit board locations.
a. 1010N-1-5 SysCom Version 3, Revision. D2 or Higher
b. 1010N-2K3 I/O Board A2
c. 1010N-8M-5 I/O Board A3
d. 1010N-7K2 Analog I/O A2
5. PRELIMINARY INSTALLATION NOTES AND CAUTIONS
CAUTION: It is highly recommended that installation be done in a static free
environment or damage to the 1015N-2M Modem Card may result.
NOTE: The 1015N-2M Modem will not function if the 1010 flowmeter RS-232 port is
connected to the serial port of your PC.
NOTE: The 1015N-2M Modem will only transmit and receive data when used with
direct phone line connections (see paragraph 5.3 below for communication
connection options).
Figure 1. 1015N-2M Modem Card and Attaching Hardware
Top View Side View
Module ID Label
Captive
Screws (4)
1015N-2M
Modem Card
TB1 Network Connection
(2-Wire Hook Up)
Con 2 Network Connection
(RJ11 Connector)