Siemens 1015N-2MFM-1A - Manual (Page 14)

A-1
1015N-2MFM-1A Appendix A
APPENDIX A
“AT” COMMAND SET and “S” REGISTERS
The command set for the 1015N-2M modems is fully compatible with the Hayes AT command
set.
The modem is controlled and configured by the AT (attention command). Each command
consists of the following elements (with exception of the A/and the +++ command which
will be discussed later).
1. The two character sequence AT
2. A command
3. A command parameter
4. A carriage return
A command is not entered until a carriage return is entered. Spaces entered
are ignored. For example, to enter the command ‘Answer’, type ATA and .
Some commands do not have parameters. Any missing parameters in a command are
assigned the value zero, which may be a valid parameter for the command. AT
without a command serves as a wake up code and an “OK” appears on the screen.
The modem queues commands in a 40-character command line. The command line begins
with AT and can have several commands. A separator is not required between the
commands.
The command line format is:
AT command (parameter) command (parameter) ... (enter)
When a carriage return is received, (which terminates the command line), the commands
are performed in the order in which they are sent to the modem. If more than 40 characters
are sent to the modem, an error occurs and all commands must be re-entered.
The tables on the following pages provide the AT and S-Register commands for the PE2400.
A single asterisk (*) indicates the command is not supported by the PE2400.
A double asterisk (**) indicates that the command has a different meaning for the PE2400.