Siemens 1015N-2MFM-1A - Manual (Page 17)

A-4
1015N-2MFM-1A Appendix A
“S” Registers
Register Function
S0 Rings to auto-answer*
S1 Ring counter
S2 Escape character*
S3 Carriage return character
S4 Line feed character
S5 Backspace character
S6 Maximum time to wait for dial tone*
S7 Wait for carrier*
S8 Pause time for dial delay modifier*
S9 Carrier detect response time*
S10 Carrier loss disconnect time*
S11 DTMF Tone Duration*
S12 Escape code guard time*
S13 Reserved
S14 General bit mapped options*
S15 Reserved
S16 Test mode bit mapped options (&T)*
S17 Reserved
S18 Test timer*
S19-S20 Reserved
S21 V24/general bit mapped options*
S22 Speaker/results bit mapped options*
S23 General bit mapped options*
S24 Sleep inactivity timer
S25 Delay to DTR (CT108) off*
S26 RTS-to-CTS (CT105-to-CT106) delay*
S27 General bit mapped options*
S28 General bit-mapped options
S29 Flash modifier time
S30 Inactivity timer*
S31 General bit-mapped options
S32 XON character
S33 XOFF character
S34-S35 Reserved
S37 Line connection speed*
S38 Delay before forced hangup*
S39 Flow control*
S40 General bit-mapped options
S41 General bit-mapped options
S42-545 Reserved
S91 PSTN transmit attenuation level
S92 Fax transmit attenuation level
S95 Result code messages control*
S99 Leased line transmit level
S202 Remote access escape character
ECC S Registers
S36 LAPM failure control’
S46 Data compression control*
S48 V.42 negotiation control’
S62 Break handling control
S86 Call failure reason code
Cellular Registers
S201 Cellular transmit level
‘Register value may be stored in one of two user profiles
with the AT&W command.