Siemens 1015N-2MFM-1A - Manual (Page 19)

A-6
1015N-2MFM-1A Appendix A
“AT” COMMANDS and ‘S” REGISTERS
EXCLUSIVE TO THE PE2400
Command Factory Default Parameters / Descriptlon
%Dn n = 0 DTMF Attenuation. %Dn command sets the DTMF transmit level attenuation.
n = 0 0 dB attenuation
n =1 2 dB attenuation
n = 2 4 dB attenuation
n = 3 6 dB attenuation
n = 4 8 dB attenuation
n = 5 10 dB attenuation
n = 6 12 dB attenuation
n = 7 14 dB attenuation
%Ln n = 0 Transmit Attenuation. %Ln command sets the transmit level attenuation.
n = 0 0 dB attenuation
n = 1 2 dB attenuation
n = 2 4 dB attenuation
n = 3 6 dB attenuation
n = 4 8 dB attenuation
n = 5 10 dB attenuation
n = 6 12 dB attenuation
n = 7 14 dB attenuation
Percent (AT%) Commands
Command Factory Default Parameters / Descrlptlon
&Dn n = 0 Data Terminal Ready Option. &Dn controls the Data Terminal Ready (DTR) options.
Parameters: n = 0, 1, 2, 3
n = 0 Modem ignores DTR (factory default)
n = 1 Modem assumes command state when ON-to-OFF transition Is detected
on DTR.
n = 2 Modem hangs up, assumes command state and disables auto-answer
upon detecting ON-to-OFF transition on DTR.
n = 3 Modem assumes initialization state upon detecting an ON-to-OFF transition
on DTR.
Result codes: OK
&Jn n = 0 Auxiliary Relay Control. &Jn determines how the auxiliary relay is controlled.
Parameters: n = 0.1
n = 0 The auxiliary telco relay is commanded to stay open. Suitable for RJ-11,
RJ-41 S, or RJ-45S type phone jack (factory default).
n =1 The auxiliary telco relay is controlled by off-hook/on-hook. If the modem is
off-hook, the relay is commanded to close (connecting A to A1); if the modem
is on-hook. the relay is commanded to open (disconnecting A from A1).
Suitable for RJ-12 or RJ-13 type phone jacks.
Ampersand (AT&) Commands