Siemens ADSL 50 - Manual (Page 49)

Chapter 3: Configuration
Enable NAT on this interface: If your LAN interface is set on primary LAN you should check the box of the
Enable Network Address Translation. NAT translates a private IP within one
network to a public IP address.
User Name/Password: The user name and password used to access the remote server or ISP.
Dial On Demand: If checked, under disconnected status, if any client PC sends out request for
connection, the ADSL Router will dial the ISP automatically. In this case, if the
system administrator wants to disconnect the PPP session, just click the
Disconnect button at Quick Start page.
Always On: Enabling this feature will send echo request to ISP. This prevents the connection
from being hung up by ISP.
The parameters for PPPoE configuration are generally the same as those of
PPPoA. The additional parameters are:
Service Name: Enter the name of your PPPoE service here.
Service Server: Enter the name of your PPPoE service server here.
Note: When you initially add a PVC for the PPP connection and connect to ISP, a default
routing of 0.0.0.0 is added automatically to the IP Static Routing. If you set up more than
one PVC profiles and the first PVC is deleted, then you have to manually add the default
routing.
IP Route
Static Route
This page shows all static route status and allows you to add new static IP route or delete IP route. A Static IP Routing
is a manually defined path, which determines the data-transmitting route. If your local network is composed of
multiple subnets, you may want to specify a routing path to the routing table.
You can click Create a new route to add new route.
Destination Address: The destination IP address of the network where data packets are to be sent.
49