Siemens ADSL 50 - Manual (Page 11)

Chapter 2: Installation
Belgium-Line Filters:
1. Unplug the device’s cord from the phone jack.
2. Plug the Belgium-Line Filter into the phone jack.
3. Plug the phone cord (or other device cord) into the “PHONE” jack of your Belgium-Line Filter.
4. Plug the ADSL cord into the “ADSL” jack of your Belgium-Line Filter.
4.
2.
3.
1b) ISDN
installation
If your telephone service is ISDN (SANTIS ADSL 500), proceed as follows to install your Hardware:
Remove the U-Line (incoming line) form your ISDN NT and plug it into the “LINE” plug of the ISDN Splitter.
Use another phone line to connect your ISDN NT with your ISDN Splitter. Plug this phone line onto the
“PHONE” plug of the ADSL splitter, and plug the other end of the line into the U-Line plug of your ISDN NT.
ISDN
U-line
ISDN NT
2) Use the line to connect the ADSL Microfilter or Splitter and your ADSL LAN port.
3) Please attach one end of the Ethernet cable with RJ-45 connector to the LAN port of your ADSL Router.
11