beautypg.com

Safety compliance – SMC Networks SMCWHSG44-G User Manual

Page 8

background image

to other system. The user is obligated to ensure the device is operating
according to the channel limitations, indoor/outdoor restrictions and
license requirements for each European Community country as described
in this document.

• This device may be operated indoors or outdoors in all countries of the

European Community using the 2.4 GHz band: Channels 1 - 13, except
where noted below.

• In Italy the end-user must apply for a license from the national spectrum

authority to operate this device outdoors.

• In Belgium outdoor operation is only permitted using the 2.46 - 2.4835 GHz

band: Channel 13.

• In France outdoor operation is only permitted using the 2.4 - 2.454 GHz

band: Channels 1 - 7

Notified Countries for intended use:

Austria, Belgium, Denmark, Finland, France, Germany, Italy, Luxembourg,
Netherlands, Norway, Spain, Sweden Switzerland, United Kingdom, Portugal,
Greece, Ireland, Iceland

Safety Compliance

Power Cord Safety
Please read the following safety information carefully before installing the switch:
WARNING: Installation and removal of the unit must be carried out by
qualified personnel only.

• The unit must be connected to an earthed (grounded) outlet to comply

with international safety standards.

• Do not connect the unit to an A.C. outlet (power supply) without an earth

(ground) connection.

• The appliance coupler (the connector to the unit and not the wall plug) must

have a configuration for mating with an EN 60320/IEC 320 appliance inlet.

• The socket outlet must be near to the unit and easily accessible. You can

only remove power from the unit by disconnecting the power cord from
the outlet.

• This unit operates under SELV (Safety Extra Low Voltage) conditions

according to IEC 60950. The conditions are only maintained if the
equipment to which it is connected also operates under SELV conditions.

France and Peru only
This unit cannot be powered from IT supplies. If your supplies are of IT type,
this unit must be powered by 230 V (2P+T) via an isolation transformer ratio
1:1, with the secondary connection point labelled Neutral, connected directly
to earth (ground).
† Impédance à la terre

7