Samsung Digimax V50 - Manual (Page 85)

85
Sound
If you set the operation sound to ON, various sounds will be activated for camera startup,
when button are pressed, and if there is a card error, so that you can be aware of the camera
operation status.
Setting Operation Sounds
1. In any mode other than Voice Recording mode, press the
MENU button.
2. Press the LEFT/ RIGHT button and select the [SETUP]
menu tab.
3. Select the [SOUND] menu by pressing the UP/ DOWN
button and press the RIGHT button.
4. Select a desired sub menu by pressing the UP/ DOWN
button and press the OK button.
- [SOUND] sub menu : OFF/ LOW/MEDIUM/ HIGH
You can adjust the LCD brightness.
Adjusting LCD Brightness
1. In any mode other than Voice Recording mode, press the
MENU button.
2. Press the LEFT/ RIGHT button and select the [SETUP]
menu tab.
3. Select the [LCD] menu by pressing the UP/ DOWN button
and press the RIGHT button.
4. Select a desired sub menu by pressing the UP/ DOWN
button and press the OK button.
- [LCD] sub menu : DARK, NORMAL, BRIGHT
LCD brightness
SET UP
FORMAT
DATE.TIME
IMPRINT
LAMP
SOUND
BACK: SET:OK
2592
OFF
LOW
MEDIUM
HIGH
SET UP
DATE.TIME
IMPRINT
LAMP
SOUND
LCD
BACK: SET:OK
2592
DARK
NORMAL
BRIGHT