SMC Networks TigerSwitch - Manual (Page 392)

C
OMMAND
L
INE
I
NTERFACE
4-150
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When auto-negotiation is enabled with the negotiation command, the
switch will negotiate the best settings for a link based on the
capabilites command. When auto-negotiation is disabled, you must
manually specify the link attributes with the speed-duplex and
flowcontrol commands.
Example
The following example configures Ethernet port 5 capabilities to 100half,
100full and flow control.
Related Commands
negotiation (4 -148)
speed-duplex (4 -147)
flowcontrol (4 -150)
flowcontrol
This command enables flow control. Use the no form to disable flow
control.
Syntax
[no] flowcontrol
Default Setting
Flow control enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#