SMC Networks TigerSwitch - Manual (Page 312)

C
OMMAND
L
INE
I
NTERFACE
4-70
logging sendmail source-email
This command sets the email address used for the “From” field in alert
messages. Use the no form to delete the source email address.
Syntax
[no] logging sendmail source-email email-address
email-address - The source email address used in alert messages.
(Range: 0-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
Example
This example will set the source email [email protected].
logging sendmail destination-email
This command specifies the email recipients of alert messages. Use the no
form to remove a recipient.
Syntax
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Console(config)#logging sendmail source-email [email protected]
Console(config)#