SMC Networks TigerSwitch - Manual (Page 387)

I
NTERFACE
C
OMMANDS
4-145
Interface Commands
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Table 4-40 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface
configuration mode
GC 4-146
description Adds a description to an interface configuration IC 4-146
speed-duplex Configures the speed and duplex operation of a
given interface when autonegotiation is disabled
IC 4-147
negotiation Enables autonegotiation of a given interface IC 4-148
capabilities Advertises the capabilities of a given interface for
use in autonegotiation IC 4-149
flowcontrol Enables flow control on a given interface IC 4-150
shutdown Disables an interface IC 4-151
switchport
broadcast
packet-rate Configures the broadcast storm control
threshold IC 4-152
clear counters Clears statistics on an interface PE 4-153
show
interfaces
status Displays status for the specified interface NE,
PE 4-154
show
interfaces
counters Displays statistics for the specified interfaces NE,
PE 4-155
show
interfaces
switchport Displays the administrative and operational
status of an interface NE,
PE 4-157