Samsung SRP-500 - Manual (Page 36)

63
① GS V m
② GS V m n
[Name] Feeds paper for cutting position.
[Format] ① 1 ASCll GS V m
Hex 1D 56 m
Decimal 29 86 m
② ASCll GS V m n
Hex 1D 56 m n
Decimal 29 86 m n
[Range] ① m = 1, 49 ② m = 66, 0 ≤ n ≤ 255
[Description] Feeds paper for cutting position as follows;
Bit Print mode
1, 49 Partial cut (one portion left uncut)
66 Feeds paper for ( cutting position + [n x 0.122 mm {1/192 inches}]), and partial cut.
[Notes]
• This command is effective only at the beginning of a line.
• When n = 0, the printer feeds the paper to the cutting position.
• When n , 0,the printer feeds the paper to (cutting position +[ n x 0.122 mm
{1/192 inches}]).
GS a n
[Name] Enable/Disable Automatic Status Back
[Format] ASCII GS a n
Hex 1D 61 n
Decimal 29 97 n
[Range] 0 ≤ n ≤ 255
[Description] Enables or disables ASB and specifies the status items to
include, using n as follows:
64
Bit Off/On Hex Decimal Status for ASB
Off 00 0 Drawer kick-out connector pin 3 status disabled. 0
On 01 1 Drawer kick-out connector pin 3 status enabled.
Off 00 0 On-line/off-line disabled. 1
On 02 2 On-line/off-line enabled
Off 00 0 Error status disabled. 2
On 04 4 Error status enabled.
Off 00 0 Paper roll sensor status disabled. 3
On 08 8 Paper roll sensor status enabled.
4 - - - Undefined.
5 - - - Undefined.
6 - - - Undefined.
7 - - - Undefined.
[Notes]
• Even if only one of the statuses is enabled, the status is sent when this
command is executed. Subsequently, whenever the state of a valid status
changes, that status is sent. In this case, because the current state is
shown for each status, there is a possibility of a state change for a status
for which ASB is not enabled.
• If all statuses are disabled, the Automatic Status Back (ASB) function is
disabled.
• When transmitting a status, the printer transmits only four bytes.
• Four bytes of status data must be consecutive, except for XOFF code.
• This command is executed when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving this
command and transmitting the status, depending on the receive buffer
status.
• When the printer is disabled by ESC = (Select peripheral device), this
command is disabled but ASB is not disabled.
• The status to be transmitted are as follows: