Samsung SRP-500 - Manual (Page 31)

53
ESC c 3 n
[Name] Select paper detector(s)to output paper end signals
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
[Range] 0 ≤ n ≤ 255
[Description] Selects paper detector(s) to output paper end signals,
using n as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near end sensor disabled. 0
On 01 1 Paper roll near end sensor enabled.
1 Off 00 0 Paper roll near end sensor disabled.
On 02 2 Paper roll near end sensor enabled.
Off 00 0 Paper roll end detector disabled. 2
On 04 4 Paper roll end detector enabled.
Off 00 0 Paper roll end detector disabled. 3
On 08 8 Paper roll end detector enable.
4 - - - Undefined
5 - - - Undefined
6 - - - Undefined
7 - - - Undefined
[Notes]
• It is possible to select multiple detectors to output signals.
• Then, if any of the detectors detects a paper end, the paper end signal is
output.
• Detectors are switched when executing this command.
• Because of this, the paper-out signal switching may delay depending on
the receive buffer state.
[Default] n = 15
54
ESC c 4 n
[Name] Select paper sensor(s)to stop printing
[Format] ASCll ESC c 4 n
Hex 18 63 34 n
Decimal 27 99 52 n
[Range] 0 ≤ n ≤ 255
[Description] Selects the paper sensor(s) used to stop printing when a
paper-end is detected, using n as follows :
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near end sensor disabled. 0
On 01 1 Paper roll near end sensor enabled.
Off 00 0 Paper roll near end sensor disabled. 1
On 02 2 Paper roll near end sensor enabled.
2 - - - Undefined
3 - - - Undefined
4 - - - Undefined
5 - - - Undefined
6 - - - Undefined
7 - - - Undefined
[Notes]
• The printer goes off-line after printing stops.
• The paper roll near-end sensor is an option, therefore, if the paper roll
near-end sensor is enabled by this command when the sensor is not
equipped, it does not stop printing.
• The paper roll near-end sensor is enabled when either bit 0 or 1 is 1.
• The paper roll end sensor is a sensor which is always used to make an
effective to stop printing.
[Default] n = 0