User’s guide – Silex technology SX-200 User Manual

Page 80

Text mode
Original mode

User’s Guide

Document #40182-420 Rev. A

Enable or disable WPA/WPA2 group key mode. If enabled, this allows group keys to be used for data link
encryption.
SET NW WPAGROUP [ENABLE | DISABLE]
(default = disabled)

SH NW WPAGROUP

Shows the state of the allow WPA/WPA2 group keys flag

sample output:
WPA-GROUP Disabled

SET NW WPAPSK

Sets the WPA/WPA2 PSK pass phrase or hex key. This value is only used if the authentication mode is
WPA-PSK. The argument to this command is either a pass phrase of 8-63 characters, or exactly 64 hex
characters representing the 256 bit PSK value.

SET NW WPAPSK
(default = “silex”)

SET NW WPATRACE

Sets the WPA trace level. note: this command is for diagnostic purposes only, and should not normally be
used as the trace can affect performance. A value of 0 disables the trace.

SET NW WPATRACE nn
(default = 0)