User’s guide, Set password, Set poweron – Silex technology SX-200 User Manual
Page 65: Sh poweron, Set protect, Cl protect, Save, Sh test
User’s Guide
Document #40182-420 Rev. A
65
This command instructs the server to do a soft reset when the next exit command is executed.
INIT
SET PAssword
Sets the server access (read) password
SET PAssword
(default = “ACCESS”)
SET POWERON
Sets Power on delay
SET POWERON
default == 0 (no delay)
SH POWERON
Displays Power on delay in seconds
SET PROTect
Sets update password to the string given.
SET PROTECT
(default =
CL PROTect
Sets update password to
CL PROTECT
SAVE
This command saves the current configuration to non-volatile memory. Without this command, the configuration is
not saved unless an “EXIT” command is performed.
SAVE
SH TEst
Sends the configuration data via ASCII to the serial port