Silex technology SX-200 - Manual (Page 55)

User’s Guide
Document #40182-420 Rev. A 55
SET SERVI RECeive
Set receive only mode for a service. This option is rarely required, but some host applications do not operate
properly if data is received back from the serial device.
SET SERVI RECeive [ENable | DIsable]
(default = disabled)
SET SERVI TCP
Set raw TCP port for service. If port number is zero, raw TCP is disabled on that service.
SET SERVI TCP nn
(default = 9100 for service 1, 3001 for service 2)
SET SERVI QUEUE
If enabled, and if a raw TCP port is defined, the server will queue jobs sent to that port. If disabled, jobs will be
rejected if the server is currently busy with another job.
SET SERVI QUEUE [EN | DIS]
(default = disabled)
SH SERVI SUMmary [service_num]
Shows the basic parameters for a specific service. If service_num is not provided, parameters for all services are
displayed.
Note: The command SH SERVI is equivalent to SHOW SERVI SUM
String Commands
These commands configure strings used with services and service filters.
SET STRing
Set service string table entry. (Note, String 1-11 can not be set or changed).
SET STRing ”value”
CL STRing
Clears the service string table entry.
CL STRing