beautypg.com

User’s guide, Sh nw wpaauto, Set nw wpagroup – Silex technology SX-200 User Manual

Page 44: Sh nw wpagroup, Set nw wpapsk, Set nw wpatrace, Set nw iroam

background image

User’s Guide

Document #40182-420 Rev. A

44

Enable or disable WPA auto mode. If enabled, the print server will connect to a non-WPA access point if a WPA
enabled access point is not available.

Only valid when WPA is enabled (authentication type = TKIP).

SET NW WPAAUTO [ENable | DIsable]

(default = disabled)

SH NW WPAAUTO


Shows the state of the WPA auto connect flag

sample output:

WPA-AUTO Enabled

SET NW WPAGROUP


Enable or disable WPA group key mode. If enabled, this allows group keys to be used for data link encryption.

SET NW WPAGROUP [ENABLE | DISABLE]

(default

=

disabled)

SH NW WPAGROUP


Shows the state of the allow WPA group keys flag

sample output:

WPA-GROUP Disabled

SET NW WPAPSK


Sets the WPA PSK pass phrase or hex key. This value is only used if the authentication mode is WPA-PSK. The
argument to this command is either a pass phrase of 8-63 characters, or exactly 64 hex characters representing the
256 bit PSK value.

SET NW WPAPSK

(default = “silex Group”)


SET NW WPATRACE

Sets the WPA trace level. note: this command is for diagnostic purposes only, and should not normally be used as
the trace can affect performance. A value of 0 disables the trace.

SET NW WPATRACE nn

(default = 0)

SET NW IROAM