Netware commands, User’s guide, Unprotect – Silex technology SX-200 User Manual
Page 66: Set netw advertise, Set netw enable, Set netw frame, Set netw nprinter, Set netw password, Set netw polling
User’s Guide
Document #40182-420 Rev. A
66
UNPROTECT
If an update password has been defined (SET PROTECT), this command is used to enter the password to allow
configuration items to be modified. After entering this command, the server will prompt for the update password. If
entered properly, the user will then be able to execute SET commands to modify the server configuration. This lasts
only until the console session is terminated with an EXIT command.
UNPROTect
Netware Commands
SET NETW ADvertise
Advertising frequency in seconds
SET NETW ADvertise n
(default = 60 sec)
SET NETW ENable
Enable or disable the Netware Protocol
SET NETW [ENable | DISable]
(default = enable)
SET NETW FRame
Set Netware frame type
SET NETW FRame [802.2 | 802.3 | ETHer | AUto | SNAp]
(default = AUTO)
SET NETW NPrinter
Set NPrinter mode on service
SET NETW NPrinter
SET NETW PAssword
Set password for file server
SET NETW PAssword
(default =
SET NETW POlling