Silex technology Mini Print Server PRICOM SX-300U - Manual (Page 183)

9 Appendix
Users Manual SX
Netware Setup
Tab
Factory
Default
ENABLE
PRxxxxxx
(Lower 6 digits
of Ethernet
address)
802.2
Print server
NetWare File
Server to be
connected Set the name of the file server primarily
connected to. The print server logs into the
file server set here when operating in
PSERVER mode. The print server searches
the file server automatically and logs in if
the value is blank.
-
Login
Password Set the password that is authenticated
when the print server logs into the file server
as a PSERVER mode. When the password
is set for the print server, the same
password must be set to the corresponding
file server. If the print server is connected to
two or more file servers, the same password
must be set to all the file servers.
-
Job Polling
Interval Set the interval for the print server to query
the file server for jobs in units of seconds.
Usually the value should be the default.
4
Item Explanation
Select the primary operation mode (PSERVER mode /
RPRINTER mode) of the print server. If the set mode does not
work, the print server starts in a different mode.
Select the default frame type of the print server. If the set frame
type does not work, it will be changed to a different frame type
automatically.
Specify the print server name for the print server when starting in
PSERVER mode. Because this configuration is used as the
identifier on the network in the NetWare protocol, the print server
name set must be different from other names in the NetWare
environment. It is used as a login name in connecting to the
NetWare server.
Frame Type
Send the job via NetWare
Use NetWare
Protocol
Print Server Name
Enable/Disable NetWare protocol.
Bindery Setup
PSERVER
NetWare
Printing method