Samsung D371W(i) - Manual (Page 99)

99 99
ENGLISH
After Finishing a Recording
✤ At the end of a recording you must remove the power
source.
✤ When recording with a Battery Pack, leaving the pack
on the Camcorder can reduce the life span of the
battery.
The Battery Pack should be release after recording is
completed.
1. Open the Cassette door while sliding the [TAPE
EJECT] switch in the direction or the arrow.
■ Pull the cassette compartment out automatically.
■ Please wait while the tape is completely ejected.
2. After removing the tape, close the door and store the
Camcorder in a dust free environment.
Dust and other foreign materials can cause square-
shaped noise or jerky images.
3. Set the [Power] switch to the [OFF].
4. Disconnect the power source or remove the Battery
Pack. Press the [BATTERY RELEASE] switch located
on the bottom of the Camcorder and slide the Battery
Pack in the direction of the arrow.
When you have recorded something that you wish to keep,
you can protect it so that it will not be accidentally erased.
a. Protecting a tape: Push the safety tab on the cassette
so that the hole is uncovered.
b. Removing the tape protection:
If you no longer wish to keep the recording on the
cassette, push the safety tab back so that
it covers the hole.
How to store a tape
a. Avoid places with magnets or magnetic interference.
b. Avoid humidity and dust prone places.
c. Keep the tape in an upright position and avoid storing it
in direct sunlight.
d. Avoid dropping or knocking your tapes.
Maintenance
✤ 0
✤
0
0
1. [TAPE EJECT]
0
■ 0
■ 0
2.
0
0
3. [Power] [OFF] 0
4. 0
[BATTERY RELEASE]
0
0
a. 0
b.
0
a. 0
b. 0
c. 0
d. 0
Usable Cassette Tapes
SAVE a
REC b
1
3