Samsung D371W(i) - Manual (Page 37)

ENGLISH
37 37
Basic Recording
Searching quickly for a desired scene (Setting the
ZERO MEMORY) (VP-D375W(i)/D975W(i) only)
✤ The ZERO MEMORY function works in both and
modes.
➥ page 19
✤ You can mark a point on a tape that you want to return to following
playback.
1. Set the [Power] switch to [CAMERA] or [PLAYER].
2. Set the [Mode] switch to [TAPE].
3. Press the [ZERO MEMORY] button on the remote
control before the recording or during playback at the
point where you wish to return.
■ The time code is changed to a tape counter that
is set to ZERO MEMORY with the <
0:00:00>
(ZERO MEMORY indicator).
■ If you want to cancel the ZERO MEMORY
function, press the [ZERO MEMORY] button
again.
4. Finding the zero position.
■ When you have finished playback, fast forward or
rewind the tape in stop mode.
The tape stops automatically when it reaches the
zero position.
■ When you have finished recording, set the
[Power] switch to [PLAYER] and press the
[
œ œœ œ (REW)] button.
The tape stops automatically when it reaches the
zero position.
5. The tape counter with the < > (ZERO MEMORY indicator)
disappears from the display and the tape counter is changed to the
time code.
[ Notes ]
■ In the following situations, ZERO MEMORY mode may be canceled
automatically:
- At the end of the section marked with the ZERO MEMORY
function.
- When the tape is ejected.
- When you remove the Battery Pack or power supply.
■ The ZERO MEMORY may not function correctly where there is a
break between recordings on the tape.
VP-D375W(i)/D975W(i)
✤ 0 ➥ 19
✤ 0
1. [Power] [CAMERA]
[PLAYER] 0
2. [Mode] [TAPE] 0
3.
[ZERO MEMORY] 0
■ < 0:00:00>
0
■
[ZERO MEMORY] 0
4. 0
■
0
0
■ [Power]
[PLAYER] [ œ œœ œ (REW)]
œ œœ œ 0
0
5. < >
0
[ ]
■
- 0
- 0
- 0
■ 0
œ
1